1/16/2024 0 Comments Zprint software free downloadI keep a supply of ‘bulk refill’ dye-based yellow HP10 ink ($20 from ebay for 250ml) on hand to do purges with. I replaced that connector, and my heads no longer burn out, and I get much better saturation. You can determine if you have this problem if ‘pushing’ binder into the septum using the purge kit syringe is much easier that ‘pulling’ binder via the syringe. The snap-fit binder line connector on the back of the fast axis has a one-way valve that degraded over time, and wouldn’t let binder flow to the head at more that a slow dribble. Pre-flushing the printhead with a dye-based ink resolved this issue for me. These particles clogged the mesh filter, and the printhead nozzles themselves. Turns out that the sake I was using chemically combined with the pigments in the black ink, and the pigment particles flocked into large particles. has it in 7lb buckets, if I can’t find a local supplier.Īs for the HP10 heads - I was getting similar burn-out issues turns out it I had two issues - a clogged binder line, and ‘flocking’ in the cartridge.ĭisassembling some ‘dead’ HP10 printheads, I was surprised to find that the fine mesh filter over the inkjets was clogged with a black sludge. Looking at other USG products, I’m thinking about running some USG DryStone in my Z310+ - it requires less water than HydroPerm or UltraCal 30 to set.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |